R/C Groups RCCars Crack Roll Flying Giants RC Power The E Zone Lift Zone Our Sponsors
R/C Groups  


Go Back   RC Groups > Article Archive > Liftzone Archive > Cox Models Dust Devil ARF Glider Review > Cox Models Dust Devil ARF Glider Review
Reload this Page Attachment taildone.jpg (showing 13 of total 31)
Register Blogs Classifieds Clubs Members Regions Mark Forums Read

The completed tail surfaces may be taped in place.

taildone.jpg - 46.4 KB - Views: 519
Posted by: Andy W on Jul 19, 2006 06:47 AM
The completed tail surfaces may be taped in place.
 
tailtaped.pg.jpg
I taped the ruddervators to the surfaces.
<<
 		tailpins.jpg
The tail surfaces slot onto pre-installed alignment pins.
<
 		taildone.jpg
*
 mtrmount.jpg
The motor mount and alignment jig.
>
 		mtrmountinstalled.jpg
Motor mount installed.
>>

« Previous 5 Attachments | Next 5 Attachments »

Member Map - Contact Us - FAQ - Upgraded Membership - Arcade - Archive - Top

All RCGroups content copyright 1996 - 2009 by RCGroups.com and Jim Bourke except where otherwise indicated.
Terry the transmitter, the RCGroups name and logo, The E Zone, Lift Zone, and RC Power are all trademarks of RCGroups and Jim Bourke. Please report any misuse of our trademarks using the contact form. Thank you.

Powered by vBulletin, Copyright ©2000 - 2009, Jelsoft Enterprises Ltd.