The trailing edge spar had to be bowed around the back of the wing. Following the directions, I had trouble getting it to shape. ...so...I decided I needed a few extra "hands" to help get it right. BEFORE applying any, I tested my scotch tape to ensure it

sparbowed.jpg - 73.5 KB - Views: 293
Posted by: AMCross on Jul 19, 2006 05:47 AM
The trailing edge spar had to be bowed around the back of the wing. Following the directions, I had trouble getting it to shape. ...so...I decided I needed a few extra
 
graphics.jpg
LOOK AT THAT PRINTING!
<<
accessories.jpg
Here are MOST of the accessories provided when purchasing "The Judge Complete" package -- not shown are the provided spinner (out of stock when my Judge shipped), the accessory pack items including velcro/odorless CA/kicker (hinge tape was in this package
<
sparbowed.jpg
*
spartaped.jpg
By taping the spar down at various points, I found it far easier to secure properly. Any place where adhesive seeped under my tape, it did damage the print slightly, so I had to be careful of that as well.
>
sparlong.jpg
The provided aft spar was about 3/8" too long and required clipping with a pair of wire cutters.
>>