R/C Groups RCCars Crack Roll Flying Giants RC Power The E Zone Lift Zone Our Sponsors
R/C Groups  


Go Back   RC Groups > Article Archive > Liftzone Archive > Gambler+ from Wright Brothers RC > Gambler+ from Wright Brothers RC
Reload this Page Attachment ribs_in_place.jpg (showing 9 of total 17)
Register Blogs Classifieds Clubs Members Regions Mark Forums Read

Notice how the trailing edges are pushed to the building board and below the top of the TE stock.

ribs_in_place.jpg - 71.1 KB - Views: 297
Posted by: Mitch G on Jul 19, 2006 06:47 AM
Notice how the trailing edges are pushed to the building board and below the top of the TE stock.
 
marked_te_filler.jpg
Note the pencil mark indicating where to cut the TE.
<<
 		fuselage_drying.jpg
Letting the fuselage dry.
<
 		ribs_in_place.jpg
*
 rib_fronts_up.jpg
Blurry picture, but notice that the front part of the ribs are not touching the building board.
>
 		nonconforming_rib.jpg
The spar slot on the rib only allowed the rib to slip over the spar perpendicularly even though the wing panel needs it to be on an angle.
>>

« Previous 5 Attachments | Next 5 Attachments »

Member Map - Contact Us - FAQ - Upgraded Membership - Arcade - Archive - Top

All RCGroups content copyright 1996 - 2009 by RCGroups.com and Jim Bourke except where otherwise indicated.
Terry the transmitter, the RCGroups name and logo, The E Zone, Lift Zone, and RC Power are all trademarks of RCGroups and Jim Bourke. Please report any misuse of our trademarks using the contact form. Thank you.

Powered by vBulletin, Copyright ©2000 - 2009, Jelsoft Enterprises Ltd.