R/C Groups RCCars Crack Roll Flying Giants RC Power The E Zone Lift Zone Our Sponsors
R/C Groups  


Go Back   RC Groups > Article Archive > Ezonemag Archive > Ikarus UH-1 Huey Body Kit for the Ikarus Piccolo > Ikarus UH-1 Huey Body Kit for the Ikarus Piccolo
Reload this Page Attachment img_2011.jpg (showing 10 of total 33)
Register Blogs Classifieds Clubs Members Regions Mark Forums Read

Left hand side completed with tail motor wires and tail skid, ready for mating with the other side.

img_2011.jpg - 76.8 KB - Views: 333
Posted by: WildCardNZ on Jul 19, 2006 06:47 AM
Left hand side completed with tail motor wires and tail skid, ready for mating with the other side.
 
img_2000.jpg
Foam sheet with die-cut bulkheads, formers and bleade holder.
<<
 		img_2009.jpg
The body with the main bulkhead and rear chassis mount fitted. Note the alignment mark I added to ensure the correct offset.
<
 		img_2011.jpg
*
 img_2013.jpg
The joined fuselage halves.
>
 		img_2027.jpg
The fuselage after the cabin section was removed. In this shot, you can see quite clearly the asymmetric aspects of the internal arrangements, along with the annoying gap in the cabin floor.
>>

« Previous 5 Attachments | Next 5 Attachments »

Member Map - Contact Us - FAQ - Upgraded Membership - Arcade - Archive - Top

All RCGroups content copyright 1996 - 2009 by RCGroups.com and Jim Bourke except where otherwise indicated.
Terry the transmitter, the RCGroups name and logo, The E Zone, Lift Zone, and RC Power are all trademarks of RCGroups and Jim Bourke. Please report any misuse of our trademarks using the contact form. Thank you.

Powered by vBulletin, Copyright ©2000 - 2009, Jelsoft Enterprises Ltd.