Jamie
Mar 13, 2003, 04:02 PM
Need to clean out the shed a bit. All prices in Australian dollars.
OS 91 sx-h with Hyperhead. Had about 6 gallons through it. Excellent
condition. $350
TSK mystar46 Has 4 8231s installed, older OS46 engine and yuasa exhaust,
blades many spares. Has been rebuilt after a bad crash. Like new now. New
fiberglass canopy also. $offers
Hirobo Shuttle Plus kit New in box, just add gyro, servos motor. Excellent
beginners heli. $350
MS Hornet CP. Has hacker 20,22s motor, Phoenix speed controller, 3 cell
lithiumpolymer battery, lightened gy401, 4x HS50 servos, carbon blades,
delrin main gear, speed up tails, swashplate ball, new canopy unpainted,
scale 300 canopy painted, fixed pitch parts, 2 speed 300 motors, one NIB,
carbon 3d fins, titanium main and tail shaft. Lots of other spares. Needs a
couple parts to make it perfect, but electronics and upgrades are only a
couple weeks old. Just too fiddly for me. $1000
Raptor parts. I have 3 boom, belt and tail gearbox/slider/blade grip
assemblies. Basically a full tail ready to put on, with bearings also. Most
parts are still in the plastic bags. One tail has been made, but never used.
Cost $400, $offers. (I would like to sell this complete though.
Contact me at wilsonj@dodo.net.au
--
Regards
Jamie Wilson
OS 91 sx-h with Hyperhead. Had about 6 gallons through it. Excellent
condition. $350
TSK mystar46 Has 4 8231s installed, older OS46 engine and yuasa exhaust,
blades many spares. Has been rebuilt after a bad crash. Like new now. New
fiberglass canopy also. $offers
Hirobo Shuttle Plus kit New in box, just add gyro, servos motor. Excellent
beginners heli. $350
MS Hornet CP. Has hacker 20,22s motor, Phoenix speed controller, 3 cell
lithiumpolymer battery, lightened gy401, 4x HS50 servos, carbon blades,
delrin main gear, speed up tails, swashplate ball, new canopy unpainted,
scale 300 canopy painted, fixed pitch parts, 2 speed 300 motors, one NIB,
carbon 3d fins, titanium main and tail shaft. Lots of other spares. Needs a
couple parts to make it perfect, but electronics and upgrades are only a
couple weeks old. Just too fiddly for me. $1000
Raptor parts. I have 3 boom, belt and tail gearbox/slider/blade grip
assemblies. Basically a full tail ready to put on, with bearings also. Most
parts are still in the plastic bags. One tail has been made, but never used.
Cost $400, $offers. (I would like to sell this complete though.
Contact me at wilsonj@dodo.net.au
--
Regards
Jamie Wilson