2M stabs for Falcon 600

[belouder]

Hey,

I've got a Falcon 600 I'm rehabbing to do some flying with this season and the stabs are completely useless. I have very little time to figure out and build a new set. I'm hoping someone knows a resource that would have something that would work or at least some foam cores that I could sheet and finish (much easier for me then stick built-don't ask me why-maybe it's all those little tiny miter cuts!!).

The distance between the drive and pivot rods is 1.5 inches. Not sure the diamter of rods (piano wire).

I know this sounds lame but between changing diapers and trying to keep a 100+ year old house from falling down, I get about 15 minutes around midnight to keep the flying fleet flyable!!

thanks,

BK

[target]

I might have some cores at home that are suitable, but I won't be home until Friday or maybe Saturday.
Remind me in a PM and I will see what I have.


T

[prodjx]

What's the dia. of the holes in the fin? Is there already a crank in the fuse, if there is take the fuse to a LHS or some place where there is a selection of tube's and music wire and see what fit's.

[2milehighguy]

Don't mean to jump your post, but maybe you could save time with these.If interested,$20 shipped. Tubes are 3/32" and holes are 1 1/4" apart. Sorry about the pic. Cheers,Bob.