H9 power 46 Cub servos?

[deckert]

I now have one of these. Question is this, what do you all recommend for servos? The rudder will be converted to pull-pull. We all know servos fail but I'm looking for some 'solid gear' recommendations from some users of this bird. I 'm just trying to install some servo gear that's not cheap nor failure prone. I'm pulling and selling the NIP Power 46 motor and installing a GR45 from http://www.reaperbrushless.com/ more horsepower with less weight. Ail will be driven seperately,(DX7/AR7000) no Y cabling. I'm assembling parts here & there but would really appreciate some advice on the servos. I just want reliability and quality!

Dan

[bsipro]

I had a H9 Cub over the summer setup for 3D with a Pull Pull Rudder and a Carbon Fiber push rod for Elevator .
I had a Torgue Motor 4014T 570 on 6s with a 16x8 prop.
had lots of fun Ton of power.
I used JR DS821 all the way around.

[RyanPSU21]

I had a similar sized Goldberg Cub for about 10 years that I setup with a pull-pull rudder that was glow powered. Any generic full size servo will be fine. Hitec HS311, Futaba S148 or S3001,2,3,4. You really don't need anything special.

[deckert]

Appreciate the responses.....

bsipro, I'm thinking of doing the samething. That big ugly stick ain't gonna cut the mustard. I'll make a set of custom LG as well. This gear is just 2 ugly.

Dan

[stuart warne]

Me the same, standard servo's that came with my spectrum gear work fine.

Stuart.