Lomcevac
Dec 20, 2008, 11:17 AM
I was going to try some cheap RC gyros in a flying wing but in order to get dedicated pitch and roll channels for them I had to use a v-tail/elevon hardware mixer rather than TX mixing. The problem is that with both gyros connected between the receiver and the mixer I lose one direction of aileron travel and one direction of elevator travel.
With just one gyro connected on either pitch or roll everything is fine but as soon as I connect two gyros I lose movement in one direction.
:confused:
I'm assuming this might be some sort of pulse timing issue, but would appreciate any advice.....
With just one gyro connected on either pitch or roll everything is fine but as soon as I connect two gyros I lose movement in one direction.
:confused:
I'm assuming this might be some sort of pulse timing issue, but would appreciate any advice.....