22mm outrunner

[flyingrandy55]

Don,
I need a 22mm outrunner 3000kva to turn a 4.5x4.1 or up to a 4.75x4.75 prop in a Sokol. The 28mm motors are too big to fit. I had a cheapie 10dollar imported motor in it and iut worked ok for a while. I tried to turn the shaft around and it did not like that at all! I could not stop it from wobbling.

So I am in need of one of your motors in a 22mm size? Do you make them? If so can you turn the motor shaft around?

Thanks,
Randy

[The Don]

I do not have any this small in OD that can take a lot of watts. I do have an 18mm motor that is good for about 125-150 watts.

Don

[Bare]

Don,
I need a 22mm outrunner 3000kva to turn a 4.5x4.1 or up to a 4.75x4.75 prop in a Sokol. The 28mm motors are too big to fit. I had a cheapie 10dollar imported motor in it and iut worked ok for a while. I tried to turn the shaft around and it did not like that at all! I could not stop it from wobbling.

So I am in need of one of your motors in a 22mm size? Do you make them? If so can you turn the motor shaft around?

Thanks,
Randy

If Not available here. I suggest trying the DIY route what you ask for is not a problem IF you are willing to do a bit of 'research' and then spend an hour or so winding your own.