JR10x setup

[Jebera]

Hi Dudes,

Once again need your help on finding a step by step setup for my
10X and Supra combo. :confused:

All inputs are welcome!

André
Brazil

[DProseus]

Hi. I have one of the older 10x's, but I will go through my set up and post it. Are you having trouble with the mixes?
Dick

Mixes I am using:

51 THRO>>>FLAP
POS 0 (LND switch in middle pos-normal flight)
OFFSET=0 +95
+20
SW=LND

POS1 (LND switch in down pos-launching FLAP position)
OFFSET=0 +70
0

52 AUX5>>>GEAR
POS 0 (LND switch in middle pos-normal flight)
OFFSET=0 0
0
POS 1 LND switch in down pos-launching AILE position)
OFFSET=0 64
0
SW=LND
MASTER=NORM

53 AUX2>>>FLAP
POS 0 (AUX2 switch in middle position)
OFFSET=0 0
+6

POS 1 (AUX2 switch in up position)
OFFSET=0 9
0
SW=AXU
MASTER=ORIG

54 AUX2>>>GEAR
POS 0 (AUX switch in middle position)
OFFSET=0 0
+15 (place AUX2 switch in down position to set)

POS 1 (AUX2 switch in up position)
OFFSET=0 +15
0
SW=AXU
MASTER=ORIG

55 FLAP>>>GEAR
POS 0 (flap switch in middle position)
OFFSET=0 +15
0

POS1=-39 (flap switich in down position)
OFFSET=0
SW=LND
MASTER=INCL

56 THRO>>>ELEV (This is adjusted to personal comfort)

POINT IN OUT
STICK UP 100 0
5 87 15
4 70 23
3 50 23
2 35 24
1 19 27
STICK DWN 0 40

SW=FIX
MASTER=NORM

57 AILE>>>AUX2 (mix ailerons to flaps)
POS1
OFFSET=0 -20
-20
SW=FIX
MASTER=NORM

58 AILE>>>RUDD
POS0 (LND SW IN MIDDLE POS)
OFFSET=0 +60
+60

POS 1 (LND SW IN DOWN POS)
OFFSET=+8 +150
+150
SW=LND
MASTER=NORM

Whew!! Now what you have is the LND switch in the middle position for normal flight and in the down position for launch. On my radio I go to selection 22 to control the wing style and differentials and select LND for the second position and adjust the differential to 100%. Now when you launch you will get full rudder throw and 100% differential (up aileron only).

The AUX2 switch now controls flight cambers: up switch = flap+ aileron clean
middle pos= cruse
down pos=thermal

I have found I almost never use the thermal position as the plane gets too slow and does not fly well. You could reset the values and use the up position for reflex if you desire. To do either set up for the AUX2 switch you need to remember the middle switch position is where you use SUB TRM to set the position even if it is going to be for some camber.

Hope this is clear enough.

[Jebera]

Hi D.

What a piece of work! :eek:
how much time did you spent in this post?!
Thanx man, I'll folow your tips now!

Thanxs again!

André

Brazil