Triton2 questtion

[pops52]

My Triton2 continues to time out on my 6 volt 4.5ah(?) Pb (lead acid) batteries. I have gone through multiple (continuous) charging sessions, on the same battery, only to have the charger continue to time out (I think it runs for 90-120 minutes) and the battery's voltage remains around 6.46v. Shouldn't the charger stop on its own with a fully charged battery in the 7 volt range?

I am getting about two hours pond time with it on a 600 sized (8-12v) motor. And, it also is powering my spud winch system that has about the same, or a tad bit smaller, size motor.

The Pb section in the instructions is rather sparse.

Any input would be appreciated.

[Kmot]

You can select a cut off timer on the Triton. It's possible yours is set to stop charging at either 60 minutes or 90 minutes if it was prgrammed to do so somewhere along the line. Check your programming.