Gino CP
Jul 27, 2008, 08:22 PM
I have a Hitec HS-56HB servo which I converted to digital using an Ashtek Digital Board. I've used this for almost a year with a Futaba GY401 set to digital mode for close to a year.
I am now looking at this new gyro which has these digital settings:
1520uSec, 333Hz 760uSec, 333 Hz 1520uSec, 250Hz
Can you deduce if my digitized servo will work and survive this gyro?
I am now looking at this new gyro which has these digital settings:
1520uSec, 333Hz 760uSec, 333 Hz 1520uSec, 250Hz
Can you deduce if my digitized servo will work and survive this gyro?