Help HELP HELPPPPP MX22 GYROCONTROL

[Antonio.adi]

hi i have a big problem to configure my mx22 with the gyrocontrol of rctech!!!
who can help me? when i connect the gyrocontrol in my dsc of mx22 i have a message from the radio: no trainee signal.......helpppppp

[massimo]

hi i have a big problem to configure my mx22 with the gyrocontrol of rctech!!!
who can help me? when i connect the gyrocontrol in my dsc of mx22 i have a message from the radio: no trainee signal.......helpppppp

Hello Antonio ,
Don t worry us can find a solution...:)

Watch here:
http://www.rcgroups.com/forums/showpost.php?p=10030831&postcount=6


and if you have not found the solution then...you need the Graupner MX22 master/student module and master/student cable and one fem stero Jack... after you must configure the MX22...

If you want sent to me pm.

Regards

[JMSTECH]

Giovanni, I like the new avatar ;) You need to add some text underneath it like radio doctor, or master TX ;) :cool:

[massimo]

Giovanni, I like the new avatar ;) You need to add some text underneath it like radio doctor, or master TX ;) :cool:

I like also your new avatar !!
You are always very gentle with me.
I also, had my sad moments with the configuration of my mx22 and if I can ,I want to help our friends as they helped me...

about my avatar Do not walk alone at night in the park!!!!!

http://www.vocinelweb.it/faccine/alieni/48.gif

eh eh eh !!!

[JMSTECH]

I like also your new avatar !!
You are always very gentle with me.
I also, had my sad moments with the configuration of my mx22 and if I can ,I want to help our friends as they helped me...

Ahhh just don't forget the lasagna meal when I'm in town! ;) :D


about my avatar Do not walk alone at night in the park!!!!!

http://www.vocinelweb.it/faccine/alieni/48.gif


:D :D :D :cool:

[Antonio.adi]

LADIES AND GENTLEMEN........

finally my gyrocontrol work!!!!!!!!!! i have added the trainer module for the mx 22.........he work an all the channels, fantastic....now i have only one problem!!! the jaw axe work perfectly......the problem is the pitch axis of the cam! when i switch on the gyrocontrol......the pitch go to the end point directy.......but the strange thing is.....if i push the reset button of the gyrocontrol, he go perfectly to the center....after 3 second....he go back to the high end point!!!!!!! what i can do now????????? i have tried to move the center of the servo on mx22 but with no effect!!!!!!

massimoooo where are youuuu

[ssassen]

I think it is good to see that forums users respond here, but isn't it the responsibility of RC-tech to help out their customers?

Cheers,

Sander.

[Antonio.adi]

i know my friend....but i have sended 4 emails to rc-tech.....the response was....is setting problems......i need peaple with gyrocontrol experience.....for rctech on my radio i can use only channels 1 2 3 4, but is not real, becouse, after read this forum i use the module on the channels 5 and 6!!