Help! Emaxx Not Moving!? Help!

[rawfuls]

Hi
I just got this new Emaxx, as you all know, if you saw my other thread post.
Well, after quick run, slapped on a pair of fresh batteries.

After attempting to boot the ESC, or booting the ESC. I flip the on/off switch.
Push the SEt button
And it comes on with a red light...nothing works... I'm not sure if it's my throttle trim, my throttle controls are mixed up btw(How do I fix it? Reverse throttle)...

I don't know hot to reprogram the ESC, perhaps, someone can take a video doing it?

BTW, it's the old EMaxx, the 14.4V EVX.
Please help!

[*314*john*314*]

if you know what electronics you have, you might want to look up the manual online?

what radio do you have?

[Fox Rider 4]

When you ran it, was that the first battery you tried or the second?

[rawfuls]

Both.
I found the manuals on the EVX and the 3905. I have the 14.4V, but printed both, just in case. As most parts are interchangeable.
I will let you guys know. On RCU, they advised me to dl and print, which I did, and they said it's in programming mode. Let's hope it's in programming mode, and not blinking to let me know it's gonna go south.

[rc_pro_86]

if every thing is mixed up then just unplug every thing and then one by one test it by putting it back in each slip and then use the controller to see which one goes in which place. hope this helps!

[rawfuls]

I found and printed out the EVX esc owners manual, reprogrammed, and reset all switches, to stock, out of factory... I have yet to find my charger in the mail... >.<