Brushless 70 A

[OldMann]

Hi,
I am new, and I need a electronic schem for this Brushless controller. Pleas help me.

Thank's

[BushmanLA]

If you just need a pinout:

The large red and black wires on the left are the main power lines from your battery.

The 3 large wires (red, yellow, black) on the right go to the brushless motor, the order of connections doesn't matter. However, if your motor turns the wrong way, you can swap any two wires of the three to reverse direction.

The 3 small wires with the black connector go to your receiver or similar device. The red and black are 5V and ground, the orange wire is the signal wire that takes PWM signals from the receiver as input for the speed controller.

[OldMann]

I know this, I need internal schem, because I want construction this. In Romania d'ont have this information

Thank's again

[Ron van Sommeren]

Manufacturers of course don't publish their schemes, they are not crazy :)

I hope you are not too late for this kit:
http://www.rcgroups.com/forums/showthread.php?t=826950

Have a look at these threads, my message(s) there too:
http://www.rhc.ro/forumrhc2/index.php?act=ST&f=8&t=13566
http://www.rhc.ro/forumrhc2/index.php?act=ST&f=8&t=5138
Several diy brushless controller designs:
http://www.rcgroups.com/forums/showthread.php?t=140454


Vriendelijke groeten ;) Ron van Sommeren
• int. electric fly-in (http://home.hetnet.nl/~ronvans/), Nijmegen, the Netherlands
• brushless motor building tips & tricks (http://www.rcgroups.com/forums/showthread.php?t=240993)
• diy brushless motor (http://www.yahoogroups.com/group/lrk-torquemax) discussion group
• Drive Calculator (http://www.yahoogroups.com/group/D-calc/) download & discussion group