Dilbert Firestorm
Jan 07, 2003, 09:22 PM
Hmmm......
I just glossed over the airtronics manual and noticed the BEC keyword.
I re-read the section on receiver &servo connections.
says receiver is not equipped with BEC circuitry and not to use more than 6.0
volts to power the receiver. anything higher would burn-up or destroy the
receiver. says to use 4.8-6.0 volt battery pack or speed controller that is
designed to lower teh voltage to the receiver.
I guess this is where the battery pack comes in, eh.....
really doesn't say anything about the connectors other than the B/DSC mentioned
in the diagram setup.
I just glossed over the airtronics manual and noticed the BEC keyword.
I re-read the section on receiver &servo connections.
says receiver is not equipped with BEC circuitry and not to use more than 6.0
volts to power the receiver. anything higher would burn-up or destroy the
receiver. says to use 4.8-6.0 volt battery pack or speed controller that is
designed to lower teh voltage to the receiver.
I guess this is where the battery pack comes in, eh.....
really doesn't say anything about the connectors other than the B/DSC mentioned
in the diagram setup.