afinepoint
Jan 22, 2008, 09:10 AM
Using the supplied cable to attach a JR X9303 to the RealFlight Interlink controller results in an uncontrollable aircraft. The throttle on the JR operates the aircrafts roll, the pitch operates the throttle and the roll works the pitch.
The instructions on the back of the interlink say to make sure your transmitter is in the PPM(FM) mode. Under "Trainer" section for the JR the manual reads: Make sure the Slave transmitter is in the PPM/FM modulation mode. If the slave system is a X9303 2.4, or any other system that is Spread Spectrum only, such as other JR 2.4GHz systems or Spektrum brand systems, this does not apply.
How can I make this work? I would like to continue simulator practice with the radio I will be using in the field prior to the helicopter's first flight.
Reg
The instructions on the back of the interlink say to make sure your transmitter is in the PPM(FM) mode. Under "Trainer" section for the JR the manual reads: Make sure the Slave transmitter is in the PPM/FM modulation mode. If the slave system is a X9303 2.4, or any other system that is Spread Spectrum only, such as other JR 2.4GHz systems or Spektrum brand systems, this does not apply.
How can I make this work? I would like to continue simulator practice with the radio I will be using in the field prior to the helicopter's first flight.
Reg