ajust help

[railinsp]

when ajusting tracking of blades on your heli one blade is high would you ajust the push link for that blade out or in. i was thinking out could some one help me on that. I know you should ajust a little on both blades. for some reason i,m getting confused

[LILYOTA9]

Try Adjusting It A Turn Each Way, In Then Out, You Shoud See Which Way You Needed To Adjust It

[nicolasr1]

ok wats better mini t or trex wats cheaper

[TachyonDriver]

Cheaper may not be better. Better isn't usually cheaper either.

[Rafael23cc]

when ajusting tracking of blades on your heli one blade is high would you ajust the push link for that blade out or in. i was thinking out could some one help me on that. I know you should ajust a little on both blades. for some reason i,m getting confused

This might not help you by now given the date that the post was originated, but the correct answer should have been:

Always designate a "master" blade and a "slave" blade. The master blade gets adjusted with your pitch gauge on the bench, the slave blade should be adjusted too, but just to make it match on the bench. Normally both of them will be on-track if adjusted correctly on the bench, but if you notice any out-of-track blades adjust only the "slave" blade.

This will prevent your linkage settings from being too out of whack from the designed values.

Rafael