MicroNav problem

[Valerio07]

I have some problem with my mNAV configuration settings.

This is my setup:

1) hook the PPM signal from RC receiver (JR mod R700 40 Mhz, PPM receiver)

2) "ppm.h" : we change the following parameters :
PPM_RX_TYPE 2 (it was 1 but we use JR receiver)
FLIGHT_MODE=0 (RC mode forced)

3) compile & upload the MNAV firmware

4) connect the MNAV to radio receiver by "PPM-INPUT"

5) power on MNAV and Radio Receiver
(only red led goes on)

6) power on transmitter

7) open PPM GUI from "Micro View" : I can see 31918 in each column

The problem is that i am not able to change the values working on transmitter.

What goes wrong?

Hope in your help.
Reagrds
Valerio