I am looking for a JR 9303 guru

[Boss248]

:confused: I am totally confused...I have a Gold berg bipe thst I am finally finishing. My problem is I am running 2 servos one for each but Can't get my tx to gang them together and still have trim on 1 elevator. Is the any one out there that can help. I am not a newbie just a dummy.. :rolleyes:

Boss

[staggerwing]

Boss,
You're in the wrong forum---this is giant scale elec planes

[Boss248]

Boss,
You're in the wrong forum---this is giant scale elec planes
I thought someone might have run into this problem..what forum should I be in..>>>

Boss

[spyderron]

This should get you going in the right direction.
http://www.rcuniverse.com/forum/m_5753454/anchors_5754053/mpage_1/key_/anchor/tm.htm#5754053

If not, go to the JR site and look through the different setups they have. They explain it well. Personally, I have a matchbox on my 50cc so I don't have to adjust the rt and lt elevator endpoints manually.

Ron

[Fool]

Go into 'DEVIC SEL' set AUX2 to INH
Then go to 'WING TYPE' set ELEV mate to AUX2.
Plug the right elevator servo into elev and the left elevator servo into aux2
Use servo rev as required.


Jim

[Boss248]

Go into 'DEVIC SEL' set AUX2 to INH
Then go to 'WING TYPE' set ELEV mate to AUX2.
Plug the right elevator servo into elev and the left elevator servo into aux2
Use servo rev as required.


Jim
Thanks Jim..that did the trick..I bet I wasted 3hr. on this damned JR 9303..it;s might be futaba..who knows for sure..it might be 2.4 for all of us.. :rolleyes:

Happy Boss..I thought I was going to have to use one of the servo reverser which I have had bad reports on them.so I am delighted to say the least.