crackerbox parts

[PETEREL]

need the following parts to finish my 1/4 scale crackerbox

about 2 feet of 1/4 inch id teflon shaft tube liner
dry canister exhaust that points up for a homelite 25cc engine
two drivers
a propeller to fit the above motor--we are not going to race just some thing for me and my boys to run around the pond with

pm me with what you have

thanks :)

[ihor14448]

i have a props but i think it might be to small, its 5cm in diameter i have 2

[PETEREL]

i have a props but i think it might be to small, its 5cm in diameter i have 2

i was hoping that some one would know what size we would need?

[ihor14448]

ohhh, i have some small boat parts and a servo, how big is the boat in inches? maybe the prop is good for it

[PETEREL]

ohhh, i have some small boat parts and a servo, how big is the boat in inches? maybe the prop is good for it
boat is 48 inch long 18 ince wide powered by a gas motor

[ihor14448]

i dont really know

i think yo could, ask somebody on rc boat forum

[ronmeister]

Peterel measure the shaft first, ihor you can confirm if the prop's hole is the right size.

Ron

[ihor14448]

the hole is 5mm