Diy Rc Light Control Kit

[ice1234]

2CH LIGHT KIT CONTROL FOR 1/10 RC CAR!!!! :)
Part1:
http://www.youtube.com/watch?v=k7gkJJ46CHY

Part2:
http://www.youtube.com/watch?v=XKAnhKm9DFk

Part3:
http://www.youtube.com/watch?v=RNqig-CuPTM


MOIVE :
http://www.youtube.com/watch?v=s3OP97IoSB0


http://www.youtube.com/watch?v=eFhWlRVtz0A

NEW ｄｅｍｏ　ｆｉｌｍ
http://www.youtube.com/watch?v=tbqC_d3r0CQ
http://www.youtube.com/watch?v=UNwDdOPFZWs

[Malc C]

Ok, so you have some flashing lights controlled from the TX.... how about some info.

Did you design this, if so are you intending on sharing the code and shematic, or are you simply saying that you purchased a commercial unit and have fitted to a Skyline model car ????

[ice1234]

Ok, so you have some flashing lights controlled from the TX.... how about some info.

Did you design this, if so are you intending on sharing the code and shematic, or are you simply saying that you purchased a commercial unit and have fitted to a Skyline model car ????

i use at892051 to build this control unit.....NOT a commercial unit :mad: :mad:

i had already post the code the schematic into this forum!!!!
http://bbs.rc-evo.com/viewthread.php?tid=9202&extra=page%3D2

[Malc C]

i use at892051 to build this control unit.....NOT a commercial unit :mad: :mad:

i had already post the code the schematic into this forum!!!!
http://bbs.rc-evo.com/viewthread.php?tid=9202&extra=page%3D2

So why not say so in your original post --- Do you expect everyone to be mind readers !! :rolleyes: :rolleyes: :(

[nixxon]

Looking pretty cool :D

Do you drive a lot at night? Or maybe the lights are visible at daytime too...

[ice1234]

Looking pretty cool :D

Do you drive a lot at night? Or maybe the lights are visible at daytime too...

yes , i play it at night :D


THIS UNIT HAVE 7 MODE

mode0---- daytime mode (head LIGHT OFF ,BRAKE light on when brake applied)

mode1----night mode (head light on , brake light become 50% on when brake is not applied, if brake applied , 100% on)

mode3 to 6 ----head light can flash in different pattern

each mode can be changed by pressing the set button.

[Malc C]

Nixon, can you edit your post, there is no need to quote the first post with all the video's (as good as they are) twice in such a short space !

Ice, how about changing modes nfrom the transmiter rather than a switch on the PCB

[ice1234]

Nixon, can you edit your post, there is no need to quote the first post with all the video's (as good as they are) twice in such a short space !

Ice, how about changing modes nfrom the transmiter rather than a switch on the PCB
i have tested the 3CH version but no time to build it up. hehe.... Program and the hardware are already finished. V. V:p