Silly question - pressurising Micro Air retracts

[Tonystott]

Just got a set of these, never tried retracts before. How do I pressurise them?
All suggestions eagerly appreciated!

[jkettu]

Do you also have the reservoir, control valve, fill valve and plumbing between these?
If yes, and everything correctly connected, just pump some pressure into the resrvoir. A bicycle pump will do. Here (http://www.robart.com/install.aspx) you can find instructions for some typical installations.

[Tonystott]

Thanks for that! I have everything included, all pipes, valsves, reservoir, one-way fill valve etc, but I was unsure what to use to get the air in. It is very tiny (sub 40 grams!), so even a basketball filling needle is going to be a squeeze into the fill pipe.

Oh well, off to the sports store :)