Pheonix radio setup

[ptremb]

I've read thru the manual several times and something is unclear to me reguarding this mixing/demixing setup stuff.I set the tx for no swash(acro basicly on a 9chps),set the throttle/pitch/t-hold settings I want in the tx programing,than the program(software) does the "mixing" based off of the pitch chanel from the tx?
So if I have my head serewed on right,it's(the software) basicly the same setup as a mCCPM where the pitch servo would make the swash move up/down seperatly from the ail/ele servo inputs,unlike eCCPM that requires all 3 servos to move in unison.

[Ade]

the most realistic way to do it is to use the H-1 swash type in the 9c. then you setup your throttle and pitch curves and throttle hold as you would on the real thing.

i leave the pitch curves all stock, enable throttle hold, setup a V shaped throttle curve in idle up 1.

in phoenix you need to pick the futaba + collective profile then it should just work.

Ade

[ptremb]

Thanks ,atleast I wasn't to far off on my thinking.I just used acro as an example since h-1 and acro are basicly the same (ail/ele not mixed to/with anything,each input moves the one output) w/ the ch6↔ch3 mix disabled

[Ade]

no... H1 has throttle and pitch enabled. in acro only channel 3 moves when you move the throttle.

you can set it up with 4 channels but its more realistic to use 3+6

Ade