335 CF Blades w/A20-6XL on Trex 450se?

[brovic777]

I just purchased Hacker A20-6XL Brushless Motor & X-30 Pro Esc and left the frequency setting at 8khz. Does this need to be changed to 16khz?

I left the timing to automatic, does this need to be changed to Soft or Hard?

Also, I'm running 335 CF Blades on my Trex 450se w/17t pinion. Are these blades safe with the high head speed that is produced?

Thanks

[kyna]

Hello brovic777,

Thank you for your support of Hacker Brushless Motors. The esc comes preprogramed with everything you need except the govenor mode. It is very important that you program the esc for above 50,000 electrical RPM, which is the forth option under "Active RPM-Control, Heli-/Governormode".

The blades you have will be perfect for this combo.

Please let me know if we can be of further assistance.

Best Regards,

Kyna Veatch
Office Manager
Hacker Brushless USA

[brovic777]

Hello brovic777,
Thank you for your support of Hacker Brushless Motors. The esc comes preprogramed with everything you need except the govenor mode. It is very important that you program the esc for above 50,000 electrical RPM, which is the forth option under "Active RPM-Control, Heli-/Governormode".
The blades you have will be perfect for this combo.
Please let me know if we can be of further assistance.
Best Regards,
Kyna Veatch
Office Manager
Hacker Brushless USA

For my Active RPM-Control, I can't use my throttle curves set on my transmitter to control this instead?

Thanks

[brovic777]

Hello brovic777,

Thank you for your support of Hacker Brushless Motors. The esc comes preprogramed with everything you need except the govenor mode. It is very important that you program the esc for above 50,000 electrical RPM, which is the forth option under "Active RPM-Control, Heli-/Governormode".

The blades you have will be perfect for this combo.

Please let me know if we can be of further assistance.

Best Regards,

Kyna Veatch
Office Manager
Hacker Brushless USA


Man, using Active RPM-Control for the Hacker A20-6XL is a big NO, NO.. I freaken crashed because my headspead would not get high.

After a quick rebuild on the field, I turned off all Active RMP-Control and ran my throttle curve at 90-90-90 and it flew like the chame the Hacker motor is suppose to be..

Next flight I'm running it 100-100-100 throttle curve....