need help

[turbored21]

hey i know this is DIY but i need a bit of help i have an LRP AI ESC and one of the solder lines on the board has a broken spot in it.. ive fixed it for now with a lil dot of solder over the cracked spot "more like slightly burnt" but idk if its gonna hold this is the second time ive soldered it.. the first time i smoothed it down nicely and it immediately burnt through again

my question is.. could i jump over the burnt line with a small wire if it does it again.. ? essentially bypassing the bad spot.. the line its on is a direct line no breakoffs towards anything else

i know i dont punctuate very well i hope there isnt much issue reading this id really like to hear from some ppl with a bit more experience on this sorta thing

im new to the diy stuff.. just started building my own power supplies and such

thanks much

Turbo

[Cirip]

and it immediately burnt through again
That might be an indication that there is something else broken on the board.
Cirip

[fredhs]

Hi Turbo,

I agree with Cirip that a "burnt" repair (or did the spot "burn" because of the repair?) might be an indication of some malfunction.

A more direct answer to your question about using a wire as a bridge for a PCB trace: Sure, that is a common technique. This plus a wealth of other extremely helpful techniqes can be found here:

http://www.circuittechctr.com/guides/guides.shtml

Best of luck troubleshooting your ESC,

Fred

[turbored21]

thanks alot guys.. the ESC is functioning perfectly right now so the solder may fix it but i was just curious for future needs with it if it was possible

thanks alot for the quick responces

turbo