Clearview Heli Problem

[matthew954]

Ok, I am using Clearviews Blade CX2 Marine model to do some practice for my Blade CX (my house isn't big enough to learn to fly in and its waaayyyy to windy outside to fly in the back yard). I am flying forward with my CX2 Marine model, and when I aply some down elevator to slow down my forward inertia the motors quit and I crash. I am not sure how I can correct this problem. I am using a Parkzone 5-AP tx with a GWS serial cable for use with a JR radio. I am using PPJoy to map all the control surfaces. I do not have this problem when flying planes in Clearview, just in heli's. Any help is appreciated.

[skirtz]

Ok, I am using Clearviews Blade CX2 Marine model to do some practice for my Blade CX (my house isn't big enough to learn to fly in and its waaayyyy to windy outside to fly in the back yard). I am flying forward with my CX2 Marine model, and when I aply some down elevator to slow down my forward inertia the motors quit and I crash. I am not sure how I can correct this problem. I am using a Parkzone 5-AP tx with a GWS serial cable for use with a JR radio. I am using PPJoy to map all the control surfaces. I do not have this problem when flying planes in Clearview, just in heli's. Any help is appreciated.
Please select "Controller Setup" and check what is assigned to Throttle Hold. Check if you have the elevator control also assigned to throttle hold and when applied fully, it set's the throttle to hold. To corerct the problem, assigh key F3/F4 to throttle hold on/off.

Stefan

[matthew954]

Thanks that did the trick! No I can actually bring my heli to a stop and hover. I guess I didn't have my tx completely configured for Clearview. Thanks again.