Pet project:How do i modify my 4 in 1 receiver? or do i need to?

[omloro]

I have a 4 in 1 receiver that does not accept brushless motors. if i buy a

4 in 1 receiver that accepts BL motors I was told I would have a problem

with the channel mixing. I need a 4 in 1 that has each channel working

indipendantly, unless it is not the receiver that does the mixing but the

transmitter. In this case i would have no problem at all. I would prefer to buy

a 4 in 1 than to modify one but if modification is the only way to go the so

be it. How do i convert my receiver to accept brushless set up?

[Sparky Paul]

Presuming this 4-in-1 is a helicopter receiver, to use a brushless motor with it do it this way...
Seperate the receiver part from the whole thing. This exposes the pins which transfer the motor and rudder signal from the receiver to the signal processing module. Your brushless ESC connects as shown to the motor signal output from the receiver.
If you aren't using a Blade CP 4-in-1 or something similar, it may need a different approach