11.1 volt for 12mmx22mm Brushless micro t

[tdrinc1]

Has anyone tried or know if the Feiago 12mm 22mm brushless motor can handle 3 cell 11.1 volt? I just installed one and don't want to toast it. The spec said 7.4 max but didn't know if you could run or handle 11.1 volts :confused:

[turbored21]

it cant handle it.. itll go over amps and over rotational speed

[LosiT]

Haveyou done this yet? I would like to know if the motor held up and how much faster it was. Thanks a lot. email me at.... eurorush86@aim.com , thanks.

[turbored21]

refer to my above post