Park Hawk Diagram

[eflyer1234]

This should help some. This is a draft and a final version will be out soon.

-Jeffrey
JGRC
www.jgrc.biz

[RB]

I used a HS85MG for the rudder and there was not enough room for the Z-bend to fit between the servo case and the cf side piece. I cut the control rod and soldered on a metal link. Works great and is adjustable.

My elevator servo had to be mounted with the output forward for the stock length rod to work.

I am leaning towards a 555 rx. I have three of the GWS R4P and have gotten shot down with one of them and I don't want to trust a $200 craft to a $30 RX.

Ray

[eflyer1234]

The 555 is just ok if you take the case off. At least that is what the manufacturer says. A good dual conversion choice at a low weight is the FMA M5.

-Jeffrey
JGRC
www.jgrc.biz