Jr X-2610

[crycroft]

how hard is it to change from mode1 to mode 2
and where in melbourne can i get it done

Thank you

[euromodels]

10 minutes job

[crycroft]

10 min job is it just some springs and screws ?

[tim_mellor]

On the 2610 it is a software thing in the initial model setup. Then swap the spring and throttle slide from one side to the other :) Maybe 15 minutes but don't loose the little bits ;) The manual does tell you how but if you didn't get a manual I can find a link and post it if you are stuck.

Tim

[wiz310]

Just hold the two buttons (the scroll/chnl and increase/decrease) buttons in the up position when you turn the tx on, then scroll through to mode, and change it to the desired mode (normal people use mode 1 :D ) then push both buttons up again to get out of the setup menu. then unscrew the aerial, remove the screws from the back of the transmitter and take the back off of it and swap the springs on the vertical part of the stick from one side to the other. Easy peasy. :D