thelocust
Jul 31, 2006, 11:54 AM
I'm looking for something more than what is stock - which I think is only 2 or 3 degrees (I haven't measured).
Here's Phil's specs on the existing:
"The joiners that I supply with the Mantis/Aegea wings are 2024 aluminum, .500" dia and .065" wall thickness from Aircraft Spruce and specialty."
Is there some place I can get a new set of these relatively inexpensively - or - is it feasible for me to bend these accurately in my shop? I've never done the latter, so if anyone has any sagely advice, please, um, advise :)
Thanks!
Here's Phil's specs on the existing:
"The joiners that I supply with the Mantis/Aegea wings are 2024 aluminum, .500" dia and .065" wall thickness from Aircraft Spruce and specialty."
Is there some place I can get a new set of these relatively inexpensively - or - is it feasible for me to bend these accurately in my shop? I've never done the latter, so if anyone has any sagely advice, please, um, advise :)
Thanks!