Vladimir Supra Volz wing servos

[POF]

Hi there

Finally my Supra is on the way from Vladimir :)

So before I order some Volz Wing-Maxx-HP digital servos for the wing I would like to hear if anybody can confrm that the servos are matching the holes in the wing?

Thanks in advance.

[dhauch]

i'm thinking they will be to thick for the ailerons as i can remember.

dh

[mrfski]

I used Jr 168's on the ailerons of my Supra and they fit with a bit of room to spare.
Mart

[markapol]

I am using the Volz WingMax for the ailerons of my Supra and they fit. Barely. I had to slightly file down one edge of the case to get them completely flush but they fit fine. It's just that there is no wiggle room at all.


Mark

[Stan Myers]

Hi there

Finally my Supra is on the way from Vladimir :)

So before I order some Volz Wing-Maxx-HP digital servos for the wing I would like to hear if anybody can confrm that the servos are matching the holes in the wing?

Thanks in advance.

I have wing star and wing max in my wings. Worked great. No problems with fitting the flush mounted servo covers. You will have an issue with servo arms, will have to shorten to clear the bumps in the servo covers. Plenty of aileron throws with arm shortened to use closest hole. On the flaps I cut the arms just past the second hole(still clears the hump on servo cover) and I'm getting over 50mm flap travel. I've got my flaps set up so for first 50%of spoiler stick travel the ailerons follow the flaps and over 50% the ailerons go to crow(about 14mm) and the plane just stops in 8-10mph wind and can almost sink straight down. I've yet to be able to fly in less than 8-10 wind, but tomorrow winds are suppose to be 5mph kind of anxious to see how it lands in that previously described configuration.

I've only had mine out 3 times so far, so needless to say I'm still trimming. Its unreal how it responds to light puffs of lift. Your going to love it.

Stan