Propeller for a Jet Steam 800

[raykendall]

Hi!

I’ve been searching for a propeller to my Jet Stream 800 for quite a while now.
I can’t find the specific measurements in any instructions maunal and my previous propeller got scattered in 1000 pieces. :cool:
Do you know the right measurements required to find an apporopriate propeller for my boat? It is not modified...

Thank you!

/Hans-Erik Sjostrom, Sweden

[n.h.schmidt]

Hi Hans
Can you tell us something about the boat? How long is it .What does it have for a Motor/motors? Do you run it on 12cells?Whats the prop shaft dia? The orginal Kyosho props were not all that good anyway. With eneough information, a better,faster and available prop can be found. n.h.schmidt

[raykendall]

Hi n.h.schmidt

The measurements for the boat are
Length 880mm
Width 205mm
Height 150mm
Weight 1.850g

It runs on one single 7,2 V battery. I don't know the shaft dia. and can't look it up right now but i've read somewhere that a "40mm 1.4 pitch" should work for the boat.

[n.h.schmidt]

Hi Again
The orginal Kyosho props were ok but,its easy to do much better. I would bet that the shaft on your boat is 4mm dia . All the larger Kyosho boats seem to use 4mm shafts. You can't go wrong using a Graupner CF2317.42 K series prop. I needed I can supply you with a U.S scource for Graupner props if you have trouble finding them . n.h.schmidt

[raykendall]

Thanks!

I will try a Graupner prop. Found a great site on the web http://www.offshoreelectrics.com/