Clone-4 3d Plane

[rcmodelbuilder]

CLONE – 4 ARF
(A modified version of Sx-3v4 by Yosito Sekiai)
Fly without destroying your airplane!!!
-ALMOST READY TO FLY 3D AEROBATIC PLANE.
-ALL CONTROLS SURFACE COVERED WITH CLEAR TAPE.

SPECIFICATION:
Wingspan: 32 in.
Wing area: 320 sq. in.
Weight: 12 oz.
Wing loading: 5.4oz/sq. ft.
Length: 35.5 in.
Radio: 4 channel with 3 sub-micro servos and 2-12” wire extensions.
Motor: brushless out runner 300 size (weight ~ 2 oz) with prop-saver.
Propeller: slow fly 10”-12” diameter and 3.8”-4.7” pitch.
Battery: Lithium polymer 2 or 3 cell pack 1000 or 1200 mAh.
Flight time: ~20 minutes.


KIT’S CONTENT

__ 4-micro control horns.
__ 4- mini-E/Z connectors
__ 1- 1/32”x18” linkage wire.
__ 1- 1-1/2”x1-1/2”x1/4”lite-plywood motor mount.
__ 4- motor mount screws
__ 1- 12” piece of Velcro.
__ 1- wing
__ 1- fuselage
__ 1- stabilizer and elevators
__ 2- ailerons
__ 1- rudder
__ 1- EPP 6mm triangle fuselage bottom
__ 1- EPP 6mm triangle for battery
__ 2- EPP 6mm motor mount
__ 1- CD manual
__ 1- drawings

For more information visit www.rcmodelbuilder.com

[Jerry Combs]

You might get more response over in the 3D forum. Most of the F3P models weigh closer to 5 ounces rather than 12 ounces.

Jerry

[rcmodelbuilder]

You might get more response over in the 3D forum. Most of the F3P models weigh closer to 5 ounces rather than 12 ounces.

Jerry

Yes that is true, but for indoor you can use the new battery 20C 600 to 700 mAh for less weigh.
This is a indoor video of the plane by the original designer.

http://www.mimei.jp/~nishiyama/movie/04062101.wmv