dougalert
Jun 07, 2006, 08:00 PM
I just bought a NSP Psyko III (molded wing, square joiner, six years in someones closet without being touched) but I didn't get the instructions and a few of the parts. I did get the plans, but I've never built this kind of plane and I have a few questions.
1) How thick is the plywood? that holds the bellcrank and brass tube?
2) What is the best order of assembly? Looks like I could back myself into a corner if not careful. My guess is: servo tray, servos, control rods in the foam plugs and into the fuse, bellcrank (best way to get in?), rudder post. Am I Close?
Any great advice that will make the plane stronger, lighter, faster, lighter would be apreciated.
1) How thick is the plywood? that holds the bellcrank and brass tube?
2) What is the best order of assembly? Looks like I could back myself into a corner if not careful. My guess is: servo tray, servos, control rods in the foam plugs and into the fuse, bellcrank (best way to get in?), rudder post. Am I Close?
Any great advice that will make the plane stronger, lighter, faster, lighter would be apreciated.