Raptor 90 se

[morillo4]

Ive had the raptor 50 v2 for a while now and fly alot of 3d with it, im thinking of getttin the 90 se version, anyone have any experience (or bad experiences for that matter) on it im thinking of putting a 91sz and 611 gyro, 9255 servos on it would apreciate some input
thanks
happy flying

[Jeff Swartz]

Great ship ;)

And you are of course looking at some great equipment to stick in there.

The SZ is currently available in the carb version, with the pump version supposed to be here in a few months. I have the SB18 on my SZ carb and its working fine.

Check out some of marcus's flying videos at team-raptor.net and you will see the power and speed of the 9255 servos...

Also, consider a good power sustem to put those high end servos if you are looking for all you can get out of it.





search the site here to see what all you can come up with for information. You also

[Paul Susbauer]

Raptor 90 SE is a good build. I hear there are a lot of guys leaving the metal frame stiffeners off to save weight. The one I built I put them on.

When you put the tail output shaft (the vertical idler gear) be sure to secure the pin going through the small gear really well. A piece of heat shrink slipped over it will help, in conjunction with a spot of glue. Those pins have a tendency to fall out from what I"ve heard, and experienced on the 90SE.

I love the fast cyclic rate, makes nice for nice tight flips.

On the topic of the 611, I wouldn't go with anything less on a ship like this. That is a rock solid combination that can't be beat.

--Paul