Harry Spillett
Mar 28, 2006, 07:11 AM
Hello,
I have a Raptor 30 V1. I recently gave it a good "once over" while I changed
out the clutch shoe and liner. I noticed some wear on one of the bolts that
hold the tail blade grips on. I am aware of an uprade hub for the version V2
is available however if I were to use this part on the V1 would I need the
V2 bearings blade grips and vertical stabilizer? I thing the diameter of the
V2 tail rotor is larger. Will the V2 fin fit on the V1, I think the mounting
holes on the gearbox are the same,
Any pointers would be good. the blade grip bearings are shot so I will need
to replace these and the original bolts anyway even if I don't upgrade.
H
I have a Raptor 30 V1. I recently gave it a good "once over" while I changed
out the clutch shoe and liner. I noticed some wear on one of the bolts that
hold the tail blade grips on. I am aware of an uprade hub for the version V2
is available however if I were to use this part on the V1 would I need the
V2 bearings blade grips and vertical stabilizer? I thing the diameter of the
V2 tail rotor is larger. Will the V2 fin fit on the V1, I think the mounting
holes on the gearbox are the same,
Any pointers would be good. the blade grip bearings are shot so I will need
to replace these and the original bolts anyway even if I don't upgrade.
H