Reflex XTR Idle up and throttle hold problem, help needed.

[rws6610]

I recently purchased Reflex XTR and have yet to figure out how to get idle ups or throttle hold to work on this sim. I've tried setting them up in the radio (Futaba T9CHP) but it doesn't work in the sim. Any help would be greatly appreciated. I've also downloaded all the upgrades thinking that this might help, but to no avail.

[dreslism]

Under the model tab is adjust parameters for that model. It brings up the page where you can specify expo for each channel. About half way down on the right is a checkbox that says have Tx do mixing or something to that effect. Check it or uncheckit, but change it to opposite what it was.

Now your Tx will have to do the mixing for the swash also I believe. I have not set mine up this way yet.

[Charlie06]

Uncheck it.

http://i3.photobucket.com/albums/y92/Charlie0664/untitled.jpg

[rws6610]

Thank you for your reply but this doesn't address my lack of idle ups or throttle hold. Any idea's?

[Rickenbacker]

You have to assign the correct channels to collective and throttle, then you can program the radio normally. I believe I have throttle on channel 3 and collective on 6, which makes all my normal heli programming work right from my Optic 6.