Help to ID this connector

[joe@tech-mp]

Hi,

This is a balancing connector from an Apex 2200 3S pack. The pin spacing is 2mm. Any ideas who makes it? JST tech support did not recognize it as theirs.

Joe

[VinceHaworth]

It does look like a pc floppy drive power connector. Get yourself an old / dead pc power supply if you want another socket. Floppy drive power connectors do not have the locking tab as shown on your picture but I do not think that will be a problem as they are usually a good tight fit anyway.

If you want the other end with the pins, unsolder one from a dead floppy drive.

www.maplin.co.uk would probably have them too.

I am a computer technician - so if you want to try some floppy connectors, I can send you as many as you want. Free!

For info: the pin spacing on a floppy drive connector is approximatly 2.5mm

[imeins]

Is it 2mm or 2.54mm (i.e. 0.1 Inch) ?