tallflyer
Nov 10, 2005, 05:56 PM
Ok I have been playing around witht this Idea and after some basic planing I came up with a concept for a good basic 3d plane one of the best parts is that it does not require any expensive hardware to build a GWS 350 motor (D) gear works just fine props being used for test are the gws 1147-1280 this might change so stay tunned
Kit started out as a mini 28" slofly 3d plane from www.slofly.com I added a 3/8 basswood square rod down the center line this will also act as the motor mount and give the fuselage the stiffness needed.
the rest of the model will be built 100% per the original plane I decided to build it as a brushed motor as you could always change it out to a brushless without much problem.
Kits are comming soon either as a do it yourself kit or as a pre build as pictured below
foam kits will be 2 for $30.00 (these kits are just the foam)
Kits with basswood included will be $17.99 each
kits with basswood installed will be $24.99
PM for more information I will be adding this kit to my website soon so stay tuned for details!
kits with the
Kit started out as a mini 28" slofly 3d plane from www.slofly.com I added a 3/8 basswood square rod down the center line this will also act as the motor mount and give the fuselage the stiffness needed.
the rest of the model will be built 100% per the original plane I decided to build it as a brushed motor as you could always change it out to a brushless without much problem.
Kits are comming soon either as a do it yourself kit or as a pre build as pictured below
foam kits will be 2 for $30.00 (these kits are just the foam)
Kits with basswood included will be $17.99 each
kits with basswood installed will be $24.99
PM for more information I will be adding this kit to my website soon so stay tuned for details!
kits with the