Esky Honey bee Cp2 question

[BURAZZZ]

Hi!

Im begginer in helis.
Just got Honey bee CP2 heli and have some problems.

Thing is when i start the heli it waits for few seconds to calibrate itself
and then the led got green so it means its ready for use.

Problem is it starts to do some weird things by itself without me doing
anythin on my remote station ?!?!?

It just changes the speed of rotor manically and some plate angle . I
suppose its the gyro sensitivity to high ==??
Or what ?


Manual says gyro set to high is for begginers and low for experiance users
and 3d flyers ..


THX !!!

Get the RX antenna wire isolated from the carbon fiber slid supports, and
you will probably cure a lot of the glitching.


"BURAZZZ" <burazzzzzz@buraz.hr> wrote in message
news:dke3c0$mgb$1@ss405.t-com.hr...
> Hi!
>
> Im begginer in helis.
> Just got Honey bee CP2 heli and have some problems.
>
> Thing is when i start the heli it waits for few seconds to calibrate
> itself and then the led got green so it means its ready for use.
>
> Problem is it starts to do some weird things by itself without me doing
> anythin on my remote station ?!?!?
>
> It just changes the speed of rotor manically and some plate angle . I
> suppose its the gyro sensitivity to high ==??
> Or what ?
>
>
> Manual says gyro set to high is for begginers and low for experiance users
> and 3d flyers ..
>
>
> THX !!!
>
>
>
>
>

[dingo]

make sure the transmitter is ON


<dalite01@bellsouth.net> schreef in bericht
news:1Pwaf.34858$x6.4253@bignews6.bellsouth.net...
> Get the RX antenna wire isolated from the carbon fiber slid supports, and
> you will probably cure a lot of the glitching.
>
>
> "BURAZZZ" <burazzzzzz@buraz.hr> wrote in message
> news:dke3c0$mgb$1@ss405.t-com.hr...
>> Hi!
>>
>> Im begginer in helis.
>> Just got Honey bee CP2 heli and have some problems.
>>
>> Thing is when i start the heli it waits for few seconds to calibrate
>> itself and then the led got green so it means its ready for use.
>>
>> Problem is it starts to do some weird things by itself without me doing
>> anythin on my remote station ?!?!?
>>
>> It just changes the speed of rotor manically and some plate angle . I
>> suppose its the gyro sensitivity to high ==??
>> Or what ?
>>
>>
>> Manual says gyro set to high is for begginers and low for experiance
>> users and 3d flyers ..
>>
>>
>> THX !!!
>>
>>
>>
>>
>>
>
>