PDA

View Full Version : Speed controller,brushless motor and Infra-red transmitter and receiver

pear052002
Jul 27, 2005, 01:13 PM
Does anyone have PCB file of the three electronics mentioned above??
Please give me some as reference.
Ron van Sommeren
Jul 27, 2005, 06:53 PM
do-it-yourself brushless controller designs:
http://www.rcgroups.com/forums/showthread.php?t=140454
markmi
Jul 28, 2005, 03:20 AM
Start hear: http://www.cityfujisawa.ne.jp/~toko/ select English, scroll down on the right select PIC/AVR. PS controller infrared ray transmitter, 4Ch TX and No16 3Ch receiver.
And http://darkith.dyndns.org/~darkith/html/ir.shtml , 4Ch receiver
With my work on 916MHz at http://www.rcgroups.com/forums/showthread.php?t=335254 and view my gallery.
Also see: http://www.rcgroups.com/forums/showthread.php?s=&threadid=138578&highlight=diy. http://www.rcgroups.com/forums/showthread.php?s=&threadid=24711

markmi
pear052002
Jul 28, 2005, 09:08 AM
How to make Rx and Tx of infrared in the same freq.?
markmi
Jul 29, 2005, 03:23 AM
What frequency are you looking for?
Only the TX LED requires a modulated frequency, the IR receiver module decodes the RX. IR TX mentioned previously above is modulated at 56.9kHz and by holding the switch down when powering up the TX will modulate at 38kHz.

markmi