Nighthawk355
Jul 06, 2005, 07:53 PM
$1600 shipped! ran only twice! brand new 05 equipment! Not even a full tank has been ran through her!!
Story:
The items that are for sale are all 2005, bought from mid May 2005 through June 2005. I personally assembled the boat I finished assembling her the week of June 20th 2005 Sadly, I underestimated how much it would cost EXTRA just to assemble her, and went way over my budget and being a college student, I don’t have money for college now, nor just for regular living and therefore was forced to make the decision to give up this wonderful boat, just after having it for 7 days!!!.The following information is for the selling of this fully assembled, almost operational, awesome boat.
What the buyer is paying for:
Engine:
- BH Hanson 25.6CC 5.3hp modified Zenoah 260 PUM
- 3” 90 degree exhaust system with BH Hanson tuned pipe
- BH Hanson quick release motor mounts
- BH Hanson throttle cable and drive kit collet
- BH Hanson Zenoah clutch
- Includes all information that was sent by BH Hanson (break-in instructions, carburetor settings, Zenoah owners manual, sparkplug remover, pipe instructions, and other important info about the engine.
Equipment: Bonzi’ anodized orange
- Euro fountain 64 inches – Yellow
- Bonzi CZ inline drive system – Dual water pick-up
- Complete square flex cable, furrel (has fractures at each corner of the square, trying to replace), prop shaft, washers
- Two prather 275 props (sharpened and balanced, may need more work?)
- Hitech S325BB Servo
- Hitech HS-705MG Giant servo
- Bonzi Trim tabs – Stainless steal
- Fuel tank
- Extra Zenoah throttle cable
- Bonzi aluminum water outlets (two)
- WIP10 water pump
- Antenna tube, cap and mount
- Extra yellow antenna
- Kwick switch $ charging jack
- Bonzi radio box
- Water line
- Tygon fuel line 1/8” I.D
- 3M radio box seal tape
- Stuffing tube w/ liner (at the moment is cut to short, trying to replace)
- Two exhaust tips
Radio:
- 75MHZ MX-3S Synthesizer: (3 channel, non crystal computer sys pistol grip controller with 30 frequencies!. Also has all those adjustments sub, arc, d/r etc.) Included: original box, and all paper work (manuals and the extra papers that came with it)
Prop balancer:
- Du-Bro
Boat stand:
- Fully built boat stand. Used 2" I.D tubing. Will color code the parts for easy assembly?
Pictures!!!:
I have TONS OF PICTURES. I documented nearly every step of putting it together!!!! Also, if they are too small to see the details, contact me about it and I would be more than happy to send the HUGE ONES via email or aim. Here is where they are at (ENJOY): http://www.64inchfountain.MyPicGallery.com
Shipping:
First off, for me to just receive the fiberglass boat hull with hatch, radio box, some parts, and radio box cost me $126.89. That was ground (UPS 4 day shipping) from Carmel, IN 46082 Bonzi’ Sports. I am in Beaverton Oregon. That’s without it being assembled. So that can sort of give you an idea of what shipping would cost. (Contact me about arranging it)
Returns:
Because i will put the money i receive to use soon after i receive it, i cannot accept returns.
Cost:
SERIOUS BUYERS ONLY PLEASE!!!!
I personally put about $2,200 into her (because of extra tools and parts i had to buy). I know, just as a car is driven off the lot brand new, it depreciates in cost. But the boat is brand new, will have only one tank of gas ran through (to slightly break her in for ya), ready to run and includes radio. All you do when you get the package is maybe assembling some things (such as rudder and boat stand) install some batteries, mix your fuel, and she’s ready to GO!!!!!) I AM ASKING $1600 SHIPPED, but am open to other arrangements as well. please contact me if you have an offer.
IMPORTANT:
Everything above is what the buyer will receive upon me receiving the full payment. This is a AS IS sell since there is no warranty, accept on the engine (i believe). Buyer must contact me in order to arrange shipping costs and of any concerns or special requests (such as how they want this packaged). Since my father does own a business, I will be accepting payments of visa, master, discovery, and money orders (be sure to confirm this with me before purchase). The boat will take 1-5 days to ship out AFTER RECEIVING THE PAYMENT, being that I personally want to double check and make sure everything is sent out at once and that everything is there so the buyer is satisfied when they receive the package, no disappointments. “Better safe than sorry ya know?”
Contacts:
Please feel free to contact me any time of day, either by phone (must email me for number), email (nighthawk355@hotmail.com), AIM (nighthawk355), or PM's.
Verification:
I know I am new to this forum. But I assure you that I am a legit seller. You can get a hold of me via private messages, phone, email (preferred email is Nighthawk355@hotmail.com) This is because I am transferring this year to Portland State University from Portland Community College and I am not 100% sure when my email through PCC (garrett.pauwels@pcc.edu) will be canceled. So by sending emails through hotmail to me, I will for sure receive them. Also you can verify me through my fathers business: http://www.kisslerscyclery.com (this is not for advertising purposes at all, just to show you that this is where the buyer’s money will be sent to Kisslers Cyclery Inc.) Best way to contact me though is email, and phone.
Thank you for your time. I know it’s pricy, but please understand my situation. Thanks.
Please feel free to contact me about any questions, ANY TIME OF DAY. SHE MUST GO!
Story:
The items that are for sale are all 2005, bought from mid May 2005 through June 2005. I personally assembled the boat I finished assembling her the week of June 20th 2005 Sadly, I underestimated how much it would cost EXTRA just to assemble her, and went way over my budget and being a college student, I don’t have money for college now, nor just for regular living and therefore was forced to make the decision to give up this wonderful boat, just after having it for 7 days!!!.The following information is for the selling of this fully assembled, almost operational, awesome boat.
What the buyer is paying for:
Engine:
- BH Hanson 25.6CC 5.3hp modified Zenoah 260 PUM
- 3” 90 degree exhaust system with BH Hanson tuned pipe
- BH Hanson quick release motor mounts
- BH Hanson throttle cable and drive kit collet
- BH Hanson Zenoah clutch
- Includes all information that was sent by BH Hanson (break-in instructions, carburetor settings, Zenoah owners manual, sparkplug remover, pipe instructions, and other important info about the engine.
Equipment: Bonzi’ anodized orange
- Euro fountain 64 inches – Yellow
- Bonzi CZ inline drive system – Dual water pick-up
- Complete square flex cable, furrel (has fractures at each corner of the square, trying to replace), prop shaft, washers
- Two prather 275 props (sharpened and balanced, may need more work?)
- Hitech S325BB Servo
- Hitech HS-705MG Giant servo
- Bonzi Trim tabs – Stainless steal
- Fuel tank
- Extra Zenoah throttle cable
- Bonzi aluminum water outlets (two)
- WIP10 water pump
- Antenna tube, cap and mount
- Extra yellow antenna
- Kwick switch $ charging jack
- Bonzi radio box
- Water line
- Tygon fuel line 1/8” I.D
- 3M radio box seal tape
- Stuffing tube w/ liner (at the moment is cut to short, trying to replace)
- Two exhaust tips
Radio:
- 75MHZ MX-3S Synthesizer: (3 channel, non crystal computer sys pistol grip controller with 30 frequencies!. Also has all those adjustments sub, arc, d/r etc.) Included: original box, and all paper work (manuals and the extra papers that came with it)
Prop balancer:
- Du-Bro
Boat stand:
- Fully built boat stand. Used 2" I.D tubing. Will color code the parts for easy assembly?
Pictures!!!:
I have TONS OF PICTURES. I documented nearly every step of putting it together!!!! Also, if they are too small to see the details, contact me about it and I would be more than happy to send the HUGE ONES via email or aim. Here is where they are at (ENJOY): http://www.64inchfountain.MyPicGallery.com
Shipping:
First off, for me to just receive the fiberglass boat hull with hatch, radio box, some parts, and radio box cost me $126.89. That was ground (UPS 4 day shipping) from Carmel, IN 46082 Bonzi’ Sports. I am in Beaverton Oregon. That’s without it being assembled. So that can sort of give you an idea of what shipping would cost. (Contact me about arranging it)
Returns:
Because i will put the money i receive to use soon after i receive it, i cannot accept returns.
Cost:
SERIOUS BUYERS ONLY PLEASE!!!!
I personally put about $2,200 into her (because of extra tools and parts i had to buy). I know, just as a car is driven off the lot brand new, it depreciates in cost. But the boat is brand new, will have only one tank of gas ran through (to slightly break her in for ya), ready to run and includes radio. All you do when you get the package is maybe assembling some things (such as rudder and boat stand) install some batteries, mix your fuel, and she’s ready to GO!!!!!) I AM ASKING $1600 SHIPPED, but am open to other arrangements as well. please contact me if you have an offer.
IMPORTANT:
Everything above is what the buyer will receive upon me receiving the full payment. This is a AS IS sell since there is no warranty, accept on the engine (i believe). Buyer must contact me in order to arrange shipping costs and of any concerns or special requests (such as how they want this packaged). Since my father does own a business, I will be accepting payments of visa, master, discovery, and money orders (be sure to confirm this with me before purchase). The boat will take 1-5 days to ship out AFTER RECEIVING THE PAYMENT, being that I personally want to double check and make sure everything is sent out at once and that everything is there so the buyer is satisfied when they receive the package, no disappointments. “Better safe than sorry ya know?”
Contacts:
Please feel free to contact me any time of day, either by phone (must email me for number), email (nighthawk355@hotmail.com), AIM (nighthawk355), or PM's.
Verification:
I know I am new to this forum. But I assure you that I am a legit seller. You can get a hold of me via private messages, phone, email (preferred email is Nighthawk355@hotmail.com) This is because I am transferring this year to Portland State University from Portland Community College and I am not 100% sure when my email through PCC (garrett.pauwels@pcc.edu) will be canceled. So by sending emails through hotmail to me, I will for sure receive them. Also you can verify me through my fathers business: http://www.kisslerscyclery.com (this is not for advertising purposes at all, just to show you that this is where the buyer’s money will be sent to Kisslers Cyclery Inc.) Best way to contact me though is email, and phone.
Thank you for your time. I know it’s pricy, but please understand my situation. Thanks.
Please feel free to contact me about any questions, ANY TIME OF DAY. SHE MUST GO!