Simple circuit to control a servo?

[Henry.]

I have searched about this without any luck but i know that i have seen it somewhere here. So is there any simple schematic for a pic or 555 that make you control an ordinary servo in a simple way?


Got another question to, not about the topic though: If i have let say a 7 amp brushless controller, is it then possible to add more powerful mosfets directly to already existing ones or replace them so that it can handle higher amps and bigger motors?

[slipstick]

Search for servo tester or servo driver. Here are four to start you off : http://www.uoguelph.ca/~antoon/gadgets/gadgets.htm

For increasing current see the many threads on DIY brushless controllers.

Steve

[Andy W]

.. or look here..
http://www.rcgroups.com/forums/showthread.php?t=380251

[Andrew0820]

I have searched about this without any luck but i know that i have seen it somewhere here. So is there any simple schematic for a pic or 555 that make you control an ordinary servo in a simple way?


555 servo driver with PCB mask (http://web2.murraystate.edu/andy.batts/ps/simpledriver.HTM)

[Henry.]

There it was, i knew it wore here somewhere. And thanks for the links! Thanks alot for your help guys!