repair die-cast parts?

[S]

Anyone have any luck repairing die-cast components--cracks etc.? If so what
products did you find worked the best? I was thinking jb-weld but haven't
tried it as of yet.

thx

Stu

[Justin Mahn]

S wrote:
> Anyone have any luck repairing die-cast components--cracks etc.? If so what
> products did you find worked the best? I was thinking jb-weld but haven't
> tried it as of yet.
>
> thx
>
> Stu

Which die-cast part? Usually when a model breaks a Die-Cast part, we
replace it with an aftermarket milled part.


Justin

[M78Ultra]

I recently repaired a cracked block with jb weld..its holding up fine so far
(after 4-5 tanks of nitro)..just used a dremel with a grinding stone and
lightly ground the area over and around the crack..filled it in and let it
dry...then sanded it down a bit...

"S" <s@s.com> wrote in message
news:2a99b$42790f32$cf7005c4$28634@PRIMUS.CA...
> Anyone have any luck repairing die-cast components--cracks etc.? If so
what
> products did you find worked the best? I was thinking jb-weld but haven't
> tried it as of yet.
>
> thx
>
> Stu
>
>
>
>
>

[S]

Thx will give the jb weld a try.


"S" <s@s.com> wrote in message
news:2a99b$42790f32$cf7005c4$28634@PRIMUS.CA...
> Anyone have any luck repairing die-cast components--cracks etc.? If so
what
> products did you find worked the best? I was thinking jb-weld but haven't
> tried it as of yet.
>
> thx
>
> Stu
>
>
>
>
>