Micro RS4 Question.

[the_atomic_punk]

Ok i just got done building the front diff.It seems alful tight!
Is this normal? I trimmed and filed all the gates on the parts and
followed the directions correctly.I also broke it down and put it back
together 3 times.Will it loosen up eventually?

[Billy Bad Assr©]

"the_atomic_punk" <microgiant@gmail.com> wrote in message
news:1107826600.600166.238100@g14g2000cwa.googlegr oups.com...
> Ok i just got done building the front diff.It seems alful tight!
> Is this normal? I trimmed and filed all the gates on the parts and
> followed the directions correctly.I also broke it down and put it back
> together 3 times.Will it loosen up eventually?

should be loose - not tight >> stock right?
I use the one-way bearings and some have slipper front drives
--
BBA
°?°
RMRL FAQ -- http://www.faqs.org/faqs/models/rc-cars/newbie-guide/
BBA's RC Site - http://www.billybadassrc.com
When Privacy Matters -- http://www.epic.org

[Nithog]

It's a *&%$# to get it aligned properly, the directions in the manual are
wrong.
Use the out drives when building it, it will click if it's not aligned
right.
I don't use grease on my gears, instead I use lightning lube for bicycle
chains it's paraffin based.
Then loose the 2 black plastic covers, and put the aluminum can back on.
Now I think you'll find a difference.
Mine like that is just as smooth as my friends front ball diffs.
Good luck.

"the_atomic_punk" <microgiant@gmail.com> wrote in message
news:1107826600.600166.238100@g14g2000cwa.googlegr oups.com...
> Ok i just got done building the front diff.It seems alful tight!
> Is this normal? I trimmed and filed all the gates on the parts and
> followed the directions correctly.I also broke it down and put it back
> together 3 times.Will it loosen up eventually?
>

[the_atomic_punk]

Its stock.Just got the kit.I assume it should be loose,thats why i
posted.I dont think i want to go with one way bearing.I plan on using a
speed controller with reverse.

[the_atomic_punk]

I take that no one else has encountered this problem on a micro RS4?