epkoncept
Jan 06, 2005, 04:02 PM
Help:
I am also going to post this in the DIY electronics group.
After repairing the 3SL 40-6-18, it does not beep when powered up. It does not arm itself normally, and nor does it beep when I put the programming jumper on it. However, if I power it up, and offset the min throttle position to a certain low level, it will arm and the controller seems to function normally.
Does anyone happen to know what criteria or conditions are required to make the 3SL beep(it is a 1998 vintage controller)
EP
I am also going to post this in the DIY electronics group.
After repairing the 3SL 40-6-18, it does not beep when powered up. It does not arm itself normally, and nor does it beep when I put the programming jumper on it. However, if I power it up, and offset the min throttle position to a certain low level, it will arm and the controller seems to function normally.
Does anyone happen to know what criteria or conditions are required to make the 3SL beep(it is a 1998 vintage controller)
EP