Help! BR won't start up

[pjblink]

:( :( :( My Bladerunner will no longer start up. After about 2 weeks of it it has literally stopped working. It's been fantastic and the motors were not wearing out at all. It is a black bodied 27mhz and have done catkiller and removed canopy. The BR is fully charged and i have already tried replacing the battery in the TX. All the solder points seem intact and the boom wires are all solid! Any thoughts?

Thanks for ANY help!!

Patch

[petter]

pjblink
Have you been able to determine if it is the Rx or Tx? If it is the Rx it might be the switch that is broken. There have been a few posts earlier about a helicopter just falling out of the “sky” and then it was the switch. If you can measure the voltage with an instrument you should check this by measuring the voltage between the black wire from the battery and the brown wire from the motor. It shall be about 4 volts when the switch is ON.

Petter

[Kwok_Yu]

pjblink,
Did you miss my post #649 on the main BR thread? It's a simple way to check the switch. Or is it not the switch?