Poly-Quest Multi Connector

[Bill M.]

This message from "Bill M." <mayberrywj@westman.wave.ca> brought to you by EFLIGHT!

Hi,

In order to make charging my lipo packs safer, I purchased a Poly-Quest PCM-Guard. It prevents overcharge due to cell imbalance. In order for it to operate, your battery packs have to have a Poly-Quest Multi Connector installed. The following link shows how the Poly-Quest Multi Connector is to be installed.
http://www.aircraft-world.com/prod_datasheets/pcmguard.htm

I'm still not quite sure if I installed it correctly and wondered if anyone out there has installed one of these, successfully, and it they have a picture of the installation they could share?

If these were NiCads, I'd probably just plug it in and try it. I'm not willing to do that with lipos. :)

Thanks,
Bill


*** Any complaints or problems? Send an email to monitor@ezonemag.com
*** For help with list commands go to http://www.ezonemag.com/pages/mailhelp.htm
*** For the list rules go to http://www.ezonemag.com/pages/mailrule.htm

[Air Craft - Friends]

This message from "Air Craft - Friends" <friends@aircraftjapan.com> brought to you by EFLIGHT!

Hi Bill,

Send me a close-up picture of your pack with PCM Guard wires installed, and
I'll check it for you.
tech@aircraft-world.com

Let me know what cell type you have, and how many cells in the pack, just to
be sure...

Also, you need to follow the wiring diagram on
http://www.aircraft-world.com/prod_datasheets/pcmguard.htm
for the type of pack you have (2S, 3S, or 4S), and use your voltmeter to
check the connections.

All the Best,

David
AC

----- Original Message -----
From: "Bill M." <mayberrywj@westman.wave.ca>
To: <eflight@ezonemag.com>
Sent: Thursday, September 23, 2004 9:40 PM
Subject: [EFLT] Poly-Quest Multi Connector


This message from "Bill M." <mayberrywj@westman.wave.ca> brought to you by
EFLIGHT!

Hi,

In order to make charging my lipo packs safer, I purchased a Poly-Quest
PCM-Guard. It prevents overcharge due to cell imbalance. In order for it
to operate, your battery packs have to have a Poly-Quest Multi Connector
installed. The following link shows how the Poly-Quest Multi Connector is
to be installed.
http://www.aircraft-world.com/prod_datasheets/pcmguard.htm

I'm still not quite sure if I installed it correctly and wondered if anyone
out there has installed one of these, successfully, and it they have a
picture of the installation they could share?

If these were NiCads, I'd probably just plug it in and try it. I'm not
willing to do that with lipos. :)

Thanks,
Bill


*** Any complaints or problems? Send an email to monitor@ezonemag.com
*** For help with list commands go to
http://www.ezonemag.com/pages/mailhelp.htm
*** For the list rules go to http://www.ezonemag.com/pages/mailrule.htm



*** Any complaints or problems? Send an email to monitor@ezonemag.com
*** For help with list commands go to http://www.ezonemag.com/pages/mailhelp.htm
*** For the list rules go to http://www.ezonemag.com/pages/mailrule.htm